| 3-13-2026 |
All utensils and equipment shall be fully operative, clean, and in good repair. (114115, 114175). All utensils and equipment shall be approved, installed properly, and meet applicable standards. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114143, 114153, 114155, 114163, 114165, 114167, 114169, 114172, 114175, 114177, 114180, 114182)
| 1.00 |
Equipment food-contact surfaces and utensils shall be clean to sight and touch. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other debris accumulations.
Keep all food facilities, and all utensils, display cases, windows, counters, shelves, tables, refrigeration units, sinks, dishwashing machines, and other equipment or utensils used in the storage, preparation, sale, service, and display of food, clean, fully operative, and in good repair.
The non-food-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Equipment shall be reassembled so that food-contact surfaces are not contaminated.
|
1. Observed shelving inside walk-in cooler for beverages (opposite of entrance) had large accumulation of debris and dust. Increase frequency and efficacy of cleaning.
2. Observed dust accumulation on fans in walk in opposite of entrance. Increase frequency and efficacy of cleaning.
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|
| 3-13-2026 |
An adequate, protected, pressurized, potable supply of hot water and cold water shall be provided at all times. (113953(c), 114099.2(b) 114101(a), 114189, 114192, 114192.1, 114195)
| 3.00 |
Provide hot and cold water under pressure through a mixing valve to each sink compartment. The water supply shall be from a water system approved by the health officer or the state department. An adequate, protected, pressurized, potable supply of hot water, at least 120°F, and cold water shall be provided.
Handwashing facilities shall be equipped to provide warm water under pressure for a minimum of 15 seconds. If the temperature of water provided is not readily adjustable at the faucet, the temperature of the water shall be at least 100°F, but not greater than 108°F. Handwashing facilities shall be sufficient in number and conveniently located so as to be accessible at all times for use by food employees
|
1. observed hot water at dish wash sink measured 113F dish wash sink shall have hot water of at least 120F. Correct water temperature.
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|
| 3-13-2026 |
All food employees shall have adequate knowledge of and be trained in food safety as it relates to their assigned duties. The person in charge shall have adequate knowledge of, and shall educate employees of the food facility regarding major food allergens. (113947) Food facilities that prepare, handle or serve non-prepackaged potentially hazardous food, shall have an employee who has passed an approved food safety certification examination. (113947-113947.1)
| 3.00 |
The responsibilities of the staff member certified in food safety include ensuring that all employees who handle, or have responsibility for handling, unpackaged foods of any kind have sufficient knowledge to ensure the safe preparation and /or service of the food. The nature and extent of the knowledge that each employee is required to have may be tailored, as appropriate, to the employee's duties related to food safety issues.
|
Staff were unable to provide a Food Handlers Card at time of inspection. Facility shall be able to provide a food handlers card when operating a soda machine and ice machine which have components which require proper sanitation.
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|
| 3-13-2026 |
Food employees shall keep their hands and exposed portions of their arms clean, and shall maaintain fingernails so they are cleanable. Employees are required to wash their hands: before beginning work; before handling food / equipment / utensils; as often as necessary during food preparation to remove soil and contamination; when switching from working with raw to ready-to-eat foods; after touching body parts; after using the toilet room; or any time when contamination may occur. (113952, 113953.3, 113968, 113973 (a-g). Whenever gloves are worn, they shall be changed as often as handwashing is required.
| 7.00 |
The food employee shall wash their hands and portion of arms as required, and use utensils and gloves appropriately.
|
1. Observed the operator dried their hands on a cloth towel when washing hands to clean soda nozzles. Cease this practice. Facility retrain staff to dry their hands with mounted paper towels or air dryer only. Staff required to rewash hands during inspection CDI
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|
| 3-13-2026 |
Food facilities that prepare food shall be equipped with warewashing facilities. Testing equipment and materials shall be provided to measure the applicable sanitization method. (114067(f,g), 114099, 114099.1, 114099.2, 114099.3, 114099.4, 114099.5, 114099.6, 114099.7, 114101, 114101.1, 114101.2, 114103, 114107, 114125)
| 1.00 |
Provide a sink with at least 3 compartments with 2 integral metal drainboards. The sink compartments and drainage facilities shall be large enough to accommodate the largest utensil or piece of equipment to be cleaned therein.
Clean the utensils in one of the following ways:
(1) Manual warewashing shall be accomplished by using a 3-compartment sink where the utensils are first pre-cleaned, then washed, rinsed, sanitized, and air dried. The temperature of the washing solution shall be maintained at not less than 100°F or the temperature specified on the cleaning agent manufacturer's label instructions. The utensils shall then be rinsed in clear water before being immersed in a sanitizing solution. Manual sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) Immersion for at least 30 seconds where the water temperature is maintained at 171°F or above.
(b) The application of sanitizing chemicals by immersion, manual swabbing, or brushing, using one of the following solutions:
(1) Contact with a solution of 100 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with a solution of 200 ppm quaternary ammonium for at least one minute.
(4) Contact with a solution of ozone that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations and that is generated by a device located onsite at the food facility that meets all of the requirements of 114099.6.
(c) Other methods approved by the enforcement agency.
(2) Mechanical machine warewashing shall be accomplished by using an approved machine installed and operated in accordance with the manufacturer's specifications. Soiled items to be cleaned in a warewashing machine shall be loaded in racks, trays, or baskets or onto conveyors in a position that exposes the items to the unobstructed spray during all cycles and allows the items to drain. Mechanical sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) By being cycled through equipment achieving a utensil surface temperature of 160°F or above.
(b) The mechanical application of sanitizing chemicals by pressure spraying methods using one of the following:
(1) Contact with a solution of 50 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with any chemical sanitizer that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations when used in accordance with both the sanitizer manufacturers use directions and the machine manufacturer's specifications.
Provide testing equipment and materials to adequately measure the applicable sanitization method.
|
Observed facility did not have test strips for checking PPM of sanitizer used for washing food equipment. Provide and use each time you are washing dishes.
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|
| 3-13-2026 |
All food contact surfaces of utensils and equipment shall be clean and sanitized. (113984(e), 114097, 114099.1, 114099.4, 114099.6, 114101 (b-d), 114105, 114109, 114111, 114113, 114115 (a, b, d), 114117, 114125(b), 114135, 114141)
| 7.00 |
A food facility that prepares food shall not be operating if there is no method to properly clean and sanitize equipment or utensils. A food facility shall not be operating if there is gross contamination of food contact surfaces that may result in the contamination of food products.
|
1.When asked about which sanitizer the facility used to wash the soda nozzles and ice scoop the facility operator could not provide approved sanitizer. Staff was trained in using chlorine as an approved sanitizer to sanitize dishes. Staff was unaware of using chlorine as a sanitizer and had to grab some off the store shelves as they did not have any in the back. CDI. Reach out to MCDEH for more information on approved sanitizers.
2. Observe ice scoop being stored inside a home depot construction bucket. Cease this practice. Ice is a ready to eat food and the food contact surfaces shall be smooth durable non toxic and easily cleanable. Replace bucket with commercial food grade equipment which has been approved for commercial use by an ANSI certified testing agency such as NSF, UL EPH or ETL sanitation.
3. Operator observed to be utilizing non-commercial grade equipment to wash rinse and sanitize the ice scoop and soda nozzles. Facility shall provide at least 2 buckets/basins (that can fit the ice scoop) for washing rinsing and sanitizing. Operator shall follow proper 2-comp wash technique using the commercial grade buckets or basins. 2-comp wash technique : fill one bucket with soap and one with sanitizer. Test sanitizer is proper PPM. Wash soda nozzles and ice scoop in wash basin with detergent. Empty Detergent bucket and rinse the food equipment. (do not place food equipment inside the mop sink) Place rinsed equipment into sanitizer bucket/basin for 30+ seconds depending on the sanitizer used in the solution. Buckets/Basins shall be certified by an ANSI certified testing agency such as NSF, ETL Sanitation or UL EPH as commercial food grade. Water at tap should be 120F and no less than 100F in each basin/bucket. Should facility not be able to show proper wash/rinse/sanitize technique it may be required to upgrade to a 3-compartment sink or have the soda machine and ice machine removed.
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|
| 3-13-2026 |
Handwashing soap and single use towels or drying device shall be provided in dispensers adjacent to each handwashing facility; dispensers shall be maintained in good repair. (113953.2) Adequate separate facilities shall be provided for handwashing, food preparation, and the washing of utensils and equipment. (113953, 113953.1)
| 3.00 |
Handwashing facilities shall be sufficient in number and conveniently located so as to be accessible at all times for use by food employees. Employees shall not clean their hands in a sink used for food preparation, warewashing, or in a service sink or a curbed cleaning facility used for the disposal of mop water and similar liquid waste. Do not place objects in front of the handwashing station, and do not place items, utensils or wiping cloths in the handwashing sink.
Handwashing facilities shall be equipped to provide warm water under pressure for a minimum of 15 seconds. If the temperature of water provided is not readily adjustable at the faucet, the temperature of the water shall be at least 100°F, but not greater than 108°F. Soap shall be provided in approved dispensers at, or adjacent to, handwashing facilities (no bars of soap). Single-use sanitary towels or hot-air blowers shall be provided at handwashing facilities in approved dispensing devices.
|
1. Observed lack of hand soap at the hand washing sink in the front and at the hand wash sink/mop sink. Facility shall provide hand soap in a dispenser at all hand wash sinks.
2. Observed paper towels at front hand wash sink were not in a paper towel dispenser. Provide a dispenser for paper towels.
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|
| 3-13-2026 |
Handwashing signs shall be posted in each toilet room, directing attention to the need to thoroughly wash hands after using the restroom. (113953.5)
No smoking signs shall be posted in food preparation, food storage, and warewashing areas. (113978)
Consumers shall be notified that clean tableware is to be used when they return to self-service areas such as salad bars and buffets. (114075)
Any food facility constructed before January 1, 2004 without public toilet facilities shall prominently post a sign within the food facility in a public area stating that toilet facilities are not provided. (113725.1, 114276, 114381 (e))
| 1.00 |
Post permit in a conspicuous place (It is recommended that the permit be in customer view.). Post a notice advising patrons that a copy of the most recent routine inspection report is available for review by interested parties. Keep a copy of the most recent health inspection report at the facility for customer review purposes.
Post and maintain a legible and conspicuous sign in each toilet room directing attention to the need to thoroughly wash hands after using the toilet.
Post and maintain a legible "No Smoking" sign in food preparation, food storage, and utensil washing areas.
|
1. Observed lack of a visibly posted notice to inform patrons that the facility is inspected by the local health department. Maintain a sign in a conspicuous location to inform patrons that the facility is inspected. (A copy of the required notice is available on the Merced County Environmental Health website).
2. Observed lack of knowledge of the location of a copy of the most recent health inspection at the facility location. Maintain a copy of the most recent health inspection at the facility location, and ensure that employees are aware of its whereabouts and can provide a copy for customer inspection during all hours of operation. A new copy of most recent inspection report is being provided to the facility on this date. Corrected during inspection.
|
0110 RETAIL MARKET<2000 SQ FT (HM3)
|