| 3-04-2024 |
The potable water supply shall be protected with a backflow or back siphonage protection device, as required by applicable plumbing codes. (114192) All plumbing and plumbing fixtures shall be installed in compliance with local plumbing ordinances, shall be maintained so as to prevent any contamination, and shall be kept clean, fully operative, and in good repair. Any hose used for conveying potable water shall be of approved materials, labeled, properly stored, and used for no other purpose. (114171, 114189.1, 114190, 114192.1, 114193, 114193.1, 114195, 114197, 114199, 114201, 114269)
| 1.00 |
All plumbing and plumbing fixtures shall be installed in compliance with local plumbing ordinances, shall be maintained so as to prevent any contamination, and shall be kept clean, fully operative, and in good repair.
|
Hand wash sink in the front do not work. Repair the hand washing sink and used the hand wash sink in the back until fixed.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 3-04-2024 |
All clean and soiled linens shall be properly stored; non-food items shall be stored and displayed separate from food and food-contact surfaces. (114185 - 114185.4) Utensils and equipment shall be handled and stored so as to be protected from contamination. (114067, 114074 - 114075, 114081, 114083, 114119, 114121, 114161, 114178, 114179, 114185, 114185.2, 114185.5)
| 1.00 |
Storage space for food, utensils, single-use articles, clean linens, and food-related equipment shall not be located in locker rooms, refuse rooms, mechanical rooms, under open stairwells, under lines on which water has condensed, under leaking water lines, under sewer lines that are not shielded to intercept potential drips, or under other sources of contamination.
During pauses in food preparation or dispensing, food preparation and dispensing utensils shall be stored in one of the following ways:
(1) in a potentially hazardous food with their handles above the top of the food and the container.
(2) if not a potentially hazardous food, with their handles above the top of the food within containers that can be closed.
(3) on a clean portion of the food preparation table or equipment if cleaned and sanitized at the required frequency.
(4) in running water of sufficient velocity to flush particulates to the drain.
(5) in a clean, protected location if the utensils, such as ice scoops, are used only with a food that is not potentially hazardous.
(6) in a container of water if the water is maintained at a temperature of at least 135°F and the container is cleaned at least every 24 hours or at a frequency necessary to preclude the accumulation of soil residues.
|
Observed wet stacking of chafer. Make sure all chafer are dry before stacking on top of each other.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 3-04-2024 |
Food facilities that prepare food shall be equipped with warewashing facilities. Testing equipment and materials shall be provided to measure the applicable sanitization method. (114067(f,g), 114099, 114099.1, 114099.2, 114099.3, 114099.4, 114099.5, 114099.6, 114099.7, 114101, 114101.1, 114101.2, 114103, 114107, 114125)
| 1.00 |
Provide a sink with at least 3 compartments with 2 integral metal drainboards. The sink compartments and drainage facilities shall be large enough to accommodate the largest utensil or piece of equipment to be cleaned therein.
Clean the utensils in one of the following ways:
(1) Manual warewashing shall be accomplished by using a 3-compartment sink where the utensils are first pre-cleaned, then washed, rinsed, sanitized, and air dried. The temperature of the washing solution shall be maintained at not less than 100°F or the temperature specified on the cleaning agent manufacturer's label instructions. The utensils shall then be rinsed in clear water before being immersed in a sanitizing solution. Manual sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) Immersion for at least 30 seconds where the water temperature is maintained at 171°F or above.
(b) The application of sanitizing chemicals by immersion, manual swabbing, or brushing, using one of the following solutions:
(1) Contact with a solution of 100 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with a solution of 200 ppm quaternary ammonium for at least one minute.
(4) Contact with a solution of ozone that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations and that is generated by a device located onsite at the food facility that meets all of the requirements of 114099.6.
(c) Other methods approved by the enforcement agency.
(2) Mechanical machine warewashing shall be accomplished by using an approved machine installed and operated in accordance with the manufacturer's specifications. Soiled items to be cleaned in a warewashing machine shall be loaded in racks, trays, or baskets or onto conveyors in a position that exposes the items to the unobstructed spray during all cycles and allows the items to drain. Mechanical sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) By being cycled through equipment achieving a utensil surface temperature of 160°F or above.
(b) The mechanical application of sanitizing chemicals by pressure spraying methods using one of the following:
(1) Contact with a solution of 50 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with any chemical sanitizer that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations when used in accordance with both the sanitizer manufacturers use directions and the machine manufacturer's specifications.
Provide testing equipment and materials to adequately measure the applicable sanitization method.
|
Observed excessive of sanitizer of sufficient strength on dishes and sanitizer bucket. Instructed employee in manual sanitizing techniques. Perform manual sanitization of all dishes at this location at the prescribed ppm (parts per million) for the sanitization method in use (see below). Use the correct test strips for the chemical sanitizer being used. Check the sanitizer strength at a sufficient frequency to ensure consistent sanitization of all food contact surfaces in this location.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 3-04-2024 |
Toilet facilities shall be maintained clean, sanitary and in good repair. Toilet rooms shall be separated by a well-fitting self-closing door. Toilet tissue shall be provided in a permanently installed dispenser at each toilet. The number of toilet facilities shall be in accordance with local building and plumbing ordinances. Toilet facilities shall be provided for patrons: in establishments with more than 20,000 sq ft.; establishments offering on-site food consumption. (113953, 113953.1, 113953.2, 114250, 114250.1, 114276)
| 1.00 |
Provide clean toilet facilities in good repair. Provide permanently installed toilet tissue dispenser(s) in all toilet facilities. Provide handwashing facilities within or adjacent to all toilet facilities. Soap shall be provided in dispensers at, or adjacent to, handwashing facilities. Single-use sanitary towels in dispensers or hot-air blowers shall be provided at handwashing facilities.
Customer restrooms are required for food facilities of more than 20,000 square feet if they were constructed after July 1 1984, and also applies to facilities of any size that were constructed after January 1, 2004 where there is onsite consumption of food. A "take-out only" food facility, with no seating indoors or outdoors, may not be required to provide customer restrooms. Check with the Division of Environmental Health and with the appropriate Planning Department before removing or restricting access to customer restrooms.
|
Observed empty toilet dispenser. Provide and keep toilet dispenser properly filled.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 3-04-2024 |
All utensils and equipment shall be fully operative, clean, and in good repair. (114115, 114175). All utensils and equipment shall be approved, installed properly, and meet applicable standards. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114143, 114153, 114155, 114163, 114165, 114167, 114169, 114172, 114175, 114177, 114180, 114182)
| 1.00 |
Equipment food-contact surfaces and utensils shall be clean to sight and touch. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other debris accumulations.
Keep all food facilities, and all utensils, display cases, windows, counters, shelves, tables, refrigeration units, sinks, dishwashing machines, and other equipment or utensils used in the storage, preparation, sale, service, and display of food, clean, fully operative, and in good repair.
The non-food-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Equipment shall be reassembled so that food-contact surfaces are not contaminated.
|
Observed prep refrigerator in the middle of the cook line is not working and employee stated it already has a repair order. Repair or replace refrigerator.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|