Return To Restaurant Listing | Return to Environmental Health Homepage

Facility: Quik Stop Mkt #163
Address: 401 Joseph Gallo Ct., Livingston, CA

The most recent inspection of this food facility resulted in a rating of
Satisfactory (Total Points: 12.00)
0-6  Points: Good
7-13 Points: Satisfactory
14+  Points: Unsatisfactory
Rating on date 2-08-2019: Satisfactory (Total Points: 12.00)
DateViolationPointsCorrectionInspector CommentsFacility Area
2-08-2019 The walls / ceilings shall have durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair. (114065, 114067, 114069, 114175, 114143, 114257, 114259.2, 114266, 114268, 114268.1, 114271, 114272) 2.00 All food facilities shall be kept clean, fully operative, and in good repair. Floor surfaces in all areas in which food is prepared, packaged or stored, where any utensil is washed, where refuse or garbage is stored, where janitorial facilities are located, and in all restrooms and hand washing areas shall be smooth and of durable construction and made from non absorbent material that is easily cleanable.

Each permanent food facility shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. Food facilities that are not fully enclosed on all sides and that are in operation on January 1, 1985, shall not be required to meet the requirements of this section until the facility is remodeled or has a significant menu change or a change in its method of operation. Full enclosure is not required for dining areas and certain other areas when approved for outdoor food services.
REPEAT: Observed floor sink for the coffee island area still has rubber topset coving installed completely over the grate, rendering the grate difficult to remove and impeding the cleanability of the floor sink. Buildup of debris / discoloration observed in this floor sink location. Correct this condition such that the space around the floor sink is sealed and protected even under the cabinet. This may be accomplished by removing the portion of the bottom panel inside the cabinet that is over the floor sink, and installing approved cove base inside the cabinet around the floor sink (tile cove base is recommended) and ensuring all surfaces are sealed / smooth / easily cleanable. Ensure the installation is corrected in such a way that it does not impede the ability to remove the floor sink grate for proper daily cleaning. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
2-08-2019 All utensils and equipment shall be fully operative, clean, and in good repair. (114115, 114175). All utensils and equipment shall be approved, installed properly, and meet applicable standards. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114143, 114153, 114155, 114163, 114165, 114167, 114169, 114172, 114175, 114177, 114180, 114182) 2.00 Equipment food-contact surfaces and utensils shall be clean to sight and touch. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other debris accumulations.

Keep all food facilities, and all utensils, display cases, windows, counters, shelves, tables, refrigeration units, sinks, dishwashing machines, and other equipment or utensils used in the storage, preparation, sale, service, and display of food, clean, fully operative, and in good repair.

The non-food-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Equipment shall be reassembled so that food-contact surfaces are not contaminated.
Observed dirt, grime, and / or food particle buildup between, behind, and above the soda fountain dispenser heads. Also observed minor buildup of powder residue between the cartridges and near the dispenser heads in the cappuccino machines. Improve cleaning frequency and methods to ensure all equipment is kept in an appropriate state of cleanliness; ensure all equipment surfaces are smooth and easily cleanable, and all potential food contact surfaces are cleaned and sanitized on a regular basis. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
2-08-2019 The potable water supply shall be protected with a backflow or back siphonage protection device, as required by applicable plumbing codes. (114192) All plumbing and plumbing fixtures shall be installed in compliance with local plumbing ordinances, shall be maintained so as to prevent any contamination, and shall be kept clean, fully operative, and in good repair. Any hose used for conveying potable water shall be of approved materials, labeled, properly stored, and used for no other purpose. (114171, 114189.1, 114190, 114192.1, 114193, 114193.1, 114195, 114197, 114199, 114201, 114269) 2.00 All plumbing and plumbing fixtures shall be installed in compliance with local plumbing ordinances, shall be maintained so as to prevent any contamination, and shall be kept clean, fully operative, and in good repair. Observed lack of one inch minimum air gap between the drain lines under the three compartment sink and the rim height of the floor sink. Repair or modify drain lines so that the distance between the lowest edge of the drain lines and the height of the floor sink rim allows for a minimum of a one inch air gap for ALL lines that drain to floor sinks throughout the facility. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
2-08-2019 Potentially hazardous foods shall be held at or below 41°/ 45°F or at or above 135°F. (113996, 113998, 114037, 114343(a)) 2.00 Hold potentially hazardous foods either at or above 135°F or at or below 41°F. Hold the following potentially hazardous foods at 45°F: raw shell eggs, unshucked live molluscan shellfish, pasteurized milk and pasteurized milk products in original, sealed containers. Potentially hazardous foods held for dispensing in a serving line or a salad bar (not in a display case) may be held at 45°F or less during periods not to exceed 12 hours in any 24-hour period. Discard all potentially hazardous food that has been out of an approved time and temperature range. Observed some of the "bites" and taquito type items on the warming roller units were not turning, temperatures on top of non turning items significantly cooler (10 degrees or more) than the turning items. Per discussion with staff, items were loaded on roller unit approximately 3 hours ago after being heated in the back prep area to 165 degrees or more. Discussed time control as an option, documentation and active managerial follow up requirements. For now, units turned to a hotter setting and all non turning items immediately removed and discarded. Monitor food items in this location to ensure all items are maintained at or above 135 degrees at all times, or implement and document a time control plan that does not exceed four hours for any Potentially Hazardous food items. Corrected during inspection. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
2-08-2019 Food facilities that prepare food shall be equipped with warewashing facilities. Testing equipment and materials shall be provided to measure the applicable sanitization method. (114067(f,g), 114099, 114099.1, 114099.2, 114099.3, 114099.4, 114099.5, 114099.6, 114099.7, 114101, 114101.1, 114101.2, 114103, 114107, 114125) 2.00 Provide a sink with at least 3 compartments with 2 integral metal drainboards. The sink compartments and drainage facilities shall be large enough to accommodate the largest utensil or piece of equipment to be cleaned therein.

Clean the utensils in one of the following ways:

(1) Manual warewashing shall be accomplished by using a 3-compartment sink where the utensils are first pre-cleaned, then washed, rinsed, sanitized, and air dried. The temperature of the washing solution shall be maintained at not less than 100°F or the temperature specified on the cleaning agent manufacturer's label instructions. The utensils shall then be rinsed in clear water before being immersed in a sanitizing solution. Manual sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) Immersion for at least 30 seconds where the water temperature is maintained at 171°F or above.
(b) The application of sanitizing chemicals by immersion, manual swabbing, or brushing, using one of the following solutions:
(1) Contact with a solution of 100 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with a solution of 200 ppm quaternary ammonium for at least one minute.
(4) Contact with a solution of ozone that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations and that is generated by a device located onsite at the food facility that meets all of the requirements of 114099.6.
(c) Other methods approved by the enforcement agency.

(2) Mechanical machine warewashing shall be accomplished by using an approved machine installed and operated in accordance with the manufacturer's specifications. Soiled items to be cleaned in a warewashing machine shall be loaded in racks, trays, or baskets or onto conveyors in a position that exposes the items to the unobstructed spray during all cycles and allows the items to drain. Mechanical sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) By being cycled through equipment achieving a utensil surface temperature of 160°F or above.
(b) The mechanical application of sanitizing chemicals by pressure spraying methods using one of the following:
(1) Contact with a solution of 50 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with any chemical sanitizer that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations when used in accordance with both the sanitizer manufacturers use directions and the machine manufacturer's specifications.

Provide testing equipment and materials to adequately measure the applicable sanitization method.
Observed sanitizer from dispenser above three compartment sink was initially measured at 50-100 ppm. Investigation showed a significant air bubble in the concentrate line that feeds to the intermixing valve, air bubble "chased" out of the feed line. Recheck of sanitizer now shows sanitizer at ~200 PPM. Ensure sanitizer dispensed from this unit is verified with test strips at least daily to ensure unit is dispensing sanitizer at the correct strength. Corrected during inspection. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
2-08-2019 Food shall be stored in an approved manner, in approved containers and labeled as to contents. Food shall be stored at least 6" above the floor on approved shelving. (114047, 114049, 114051, 114053, 114055, 114067(h), 114069) 2.00 Provide adequate and suitable space for the storage of food. Store food at least 6 inches off the floor. Store bulk food not stored in original packaging in containers identifying the food by common name. Food shall not be stored in locker rooms, restrooms, dressing rooms, refuse areas, or mechanical rooms; under open stairwells; under lines on which water has condensed; under leaking water lines, including leaking automatic fire sprinkler heads: or under sewer lines that are not shielded to intercept potential drips.

Only prepackaged nonpotentially hazardous food or uncut produce may be displayed or sold outdoors by a food facility if outdoor displays have overhead protection that extends over all food items, and if all food items from the outdoor display are stored inside the fully enclosed food facility at all times other than during business hours.

Products that are held by the permit holder for credit, redemption, or return to the distributor, such as damaged, spoiled, or recalled products, shall be segregated and held in designated areas that are separated from food, equipment, utensils, linens, and single-use articles. All returned or damaged food products and food products from which the label has been removed shall be separated and stored in a separate area and in a manner that shall prevent adulteration of other foods and shall not contribute to a vermin problem.



Observed open / non-intact cases of drink items sitting directly on the floor in the walk in cooler. Cease this practice. Ensure that all food that is no longer in shipping containers is stored on smooth and easily cleanable storage surfaces that are a minimum of six inches off the floor. 0110 RETAIL MARKET<2000 SQ FT (HM3)


Rating on date 11-15-2017: Good (Total Points: 2.00)
DateViolationPointsCorrectionInspector CommentsFacility Area
11-15-2017 No violations were noted during this inspection. 0.00 This food facility currently meets California Retail Food Code requirements, and is authorized by the Merced County Division of Environmental Health to be open for business. The permit is issued to the current business owner of record and is non-transferable. No violations were observed during this inspection for the RETAIL MARKET <2000 SQ FT (HM3) portion of the facility. 0110 RETAIL MARKET<2000 SQ FT (HM3)
11-15-2017 The walls / ceilings shall have durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair. (114065, 114067, 114069, 114175, 114143, 114257, 114259.2, 114266, 114268, 114268.1, 114271, 114272) 2.00 All food facilities shall be kept clean, fully operative, and in good repair. Floor surfaces in all areas in which food is prepared, packaged or stored, where any utensil is washed, where refuse or garbage is stored, where janitorial facilities are located, and in all restrooms and hand washing areas shall be smooth and of durable construction and made from non absorbent material that is easily cleanable.

Each permanent food facility shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. Food facilities that are not fully enclosed on all sides and that are in operation on January 1, 1985, shall not be required to meet the requirements of this section until the facility is remodeled or has a significant menu change or a change in its method of operation. Full enclosure is not required for dining areas and certain other areas when approved for outdoor food services.
Observed floor sink for the coffee island area has had rubber topset coving installed completely over the grate, rendering the grate difficult to remove and impeding the cleanability of the floor sink. Correct this condition such that the space around the floor sink is sealed and protected even under the cabinet. This may be accomplished by removing the portion of the bottom panel inside the cabinet that is over the floor sink, and installing approved cove base inside the cabinet around the floor sink (tile cove base is recommended) and ensuring all surfaces are sealed / smooth / easily cleanable. Ensure the installation is corrected in such a way that it does not impede the ability to remove the floor sink grate for proper daily cleaning. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)