Return To Restaurant Listing | Return to Environmental Health Homepage

Facility: Togo's Eatery
Address: 1989 Pacheco Blvd Ste A, Los Banos, CA

The most recent inspection of this food facility resulted in a rating of
Good (Total Points: 2.00)
0-6  Points: Good
7-13 Points: Satisfactory
14+  Points: Unsatisfactory
Rating on date 7-18-2024: Good (Total Points: 2.00)
DateViolationPointsCorrectionInspector CommentsFacility Area
7-18-2024 Food facilities that prepare food shall be equipped with warewashing facilities. Testing equipment and materials shall be provided to measure the applicable sanitization method. (114067(f,g), 114099, 114099.1, 114099.2, 114099.3, 114099.4, 114099.5, 114099.6, 114099.7, 114101, 114101.1, 114101.2, 114103, 114107, 114125) 2.00 Provide a sink with at least 3 compartments with 2 integral metal drainboards. The sink compartments and drainage facilities shall be large enough to accommodate the largest utensil or piece of equipment to be cleaned therein.

Clean the utensils in one of the following ways:

(1) Manual warewashing shall be accomplished by using a 3-compartment sink where the utensils are first pre-cleaned, then washed, rinsed, sanitized, and air dried. The temperature of the washing solution shall be maintained at not less than 100°F or the temperature specified on the cleaning agent manufacturer's label instructions. The utensils shall then be rinsed in clear water before being immersed in a sanitizing solution. Manual sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) Immersion for at least 30 seconds where the water temperature is maintained at 171°F or above.
(b) The application of sanitizing chemicals by immersion, manual swabbing, or brushing, using one of the following solutions:
(1) Contact with a solution of 100 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with a solution of 200 ppm quaternary ammonium for at least one minute.
(4) Contact with a solution of ozone that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations and that is generated by a device located onsite at the food facility that meets all of the requirements of 114099.6.
(c) Other methods approved by the enforcement agency.

(2) Mechanical machine warewashing shall be accomplished by using an approved machine installed and operated in accordance with the manufacturer's specifications. Soiled items to be cleaned in a warewashing machine shall be loaded in racks, trays, or baskets or onto conveyors in a position that exposes the items to the unobstructed spray during all cycles and allows the items to drain. Mechanical sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) By being cycled through equipment achieving a utensil surface temperature of 160°F or above.
(b) The mechanical application of sanitizing chemicals by pressure spraying methods using one of the following:
(1) Contact with a solution of 50 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with any chemical sanitizer that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations when used in accordance with both the sanitizer manufacturers use directions and the machine manufacturer's specifications.

Provide testing equipment and materials to adequately measure the applicable sanitization method.
1. Observed PPM of quat at dish machine measured 150PPM. Correct so PPM is 200PPM
2. Observed max temp of dish machine was 96F. repair so it is a minimum of 120F

Cease use of this equipment until it is repaired.
0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)


Rating on date 3-09-2022: Satisfactory (Total Points: 13.00)
DateViolationPointsCorrectionInspector CommentsFacility Area
3-09-2022 Food facilities that prepare food shall be equipped with warewashing facilities. Testing equipment and materials shall be provided to measure the applicable sanitization method. (114067(f,g), 114099, 114099.1, 114099.2, 114099.3, 114099.4, 114099.5, 114099.6, 114099.7, 114101, 114101.1, 114101.2, 114103, 114107, 114125) 1.00 Provide a sink with at least 3 compartments with 2 integral metal drainboards. The sink compartments and drainage facilities shall be large enough to accommodate the largest utensil or piece of equipment to be cleaned therein.

Clean the utensils in one of the following ways:

(1) Manual warewashing shall be accomplished by using a 3-compartment sink where the utensils are first pre-cleaned, then washed, rinsed, sanitized, and air dried. The temperature of the washing solution shall be maintained at not less than 100°F or the temperature specified on the cleaning agent manufacturer's label instructions. The utensils shall then be rinsed in clear water before being immersed in a sanitizing solution. Manual sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) Immersion for at least 30 seconds where the water temperature is maintained at 171°F or above.
(b) The application of sanitizing chemicals by immersion, manual swabbing, or brushing, using one of the following solutions:
(1) Contact with a solution of 100 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with a solution of 200 ppm quaternary ammonium for at least one minute.
(4) Contact with a solution of ozone that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations and that is generated by a device located onsite at the food facility that meets all of the requirements of 114099.6.
(c) Other methods approved by the enforcement agency.

(2) Mechanical machine warewashing shall be accomplished by using an approved machine installed and operated in accordance with the manufacturer's specifications. Soiled items to be cleaned in a warewashing machine shall be loaded in racks, trays, or baskets or onto conveyors in a position that exposes the items to the unobstructed spray during all cycles and allows the items to drain. Mechanical sanitization shall be accomplished in the final sanitizing rinse by one of the following:
(a) By being cycled through equipment achieving a utensil surface temperature of 160°F or above.
(b) The mechanical application of sanitizing chemicals by pressure spraying methods using one of the following:
(1) Contact with a solution of 50 ppm available chlorine solution for at least 30 seconds.
(2) Contact with a solution of 25 ppm available iodine for at least one minute.
(3) Contact with any chemical sanitizer that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations when used in accordance with both the sanitizer manufacturers use directions and the machine manufacturer's specifications.

Provide testing equipment and materials to adequately measure the applicable sanitization method.
(CDI) Observed the lack of sanitizer dispensing in the dish washer. There was no more sanitizer and dish detergent present at the time of the inspection. Provide sanitizer solution at 50PPP. New chemicals were added during the inspection. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
3-09-2022 Potentially hazardous foods shall be held at or below 41°/ 45°F or at or above 135°F. (113996, 113998, 114037, 114343(a)) 3.00 Hold potentially hazardous foods either at or above 135°F or at or below 41°F. Hold the following potentially hazardous foods at 45°F: raw shell eggs, unshucked live molluscan shellfish, pasteurized milk and pasteurized milk products in original, sealed containers. Potentially hazardous foods held for dispensing in a serving line or a salad bar (not in a display case) may be held at 45°F or less during periods not to exceed 12 hours in any 24-hour period. Discard all potentially hazardous food that has been out of an approved time and temperature range. Observed the left refrigeration unit temperature that holds the vegetables was measured between 44F - 46F during the inspection. Keep all cold potentially hazardous food items at 41F and under. Have the unit repaired/replaced so it is at 41F at all times. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
3-09-2022 Food employees shall keep their hands and exposed portions of their arms clean, and shall maaintain fingernails so they are cleanable. Employees are required to wash their hands: before beginning work; before handling food / equipment / utensils; as often as necessary during food preparation to remove soil and contamination; when switching from working with raw to ready-to-eat foods; after touching body parts; after using the toilet room; or any time when contamination may occur. (113952, 113953.3, 113968, 113973 (a-g). Whenever gloves are worn, they shall be changed as often as handwashing is required. 7.00 The food employee shall wash their hands and portion of arms as required, and use utensils and gloves appropriately. (CDI) Observed employees not washing their hands prior to wearing gloves or beginning work. All employees shall thoroughly wash their hands and that portion, if any, of their arms exposed to direct food contact by vigorously rubbing them with cleanser and warm water as required by law in all of the following instances
(1) Immediately before engaging in food preparation, including working with nonprepackaged food, clean equipment and utensils, and unwrapped single-use food containers and utensils.
(2) After touching bare human body parts other than clean hands and clean, exposed portions of arms.
(3) After using the toilet room.
(4) After caring for or handling any animal allowed in a food facility pursuant to this part.
(5) After coughing, sneezing, using a handkerchief or disposable tissue, using tobacco, eating, or drinking.
(6) After handling soiled equipment or utensils.
(7) During food preparation, as often as necessary to remove soil and contamination and to prevent cross-contamination when changing tasks.
(8) When switching between working with raw food and working with ready-to-eat food.
(9) Before initially donning gloves for working with food.
(10) Before dispensing or serving food or handling clean tableware and serving utensils in the food service area.
(11) After engaging in other activities that contaminate the hands.

The facility was educated during the inspection.
0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)
3-09-2022 Handwashing signs shall be posted in each toilet room, directing attention to the need to thoroughly wash hands after using the restroom. (113953.5)

No smoking signs shall be posted in food preparation, food storage, and warewashing areas. (113978)

Consumers shall be notified that clean tableware is to be used when they return to self-service areas such as salad bars and buffets. (114075)

Any food facility constructed before January 1, 2004 without public toilet facilities shall prominently post a sign within the food facility in a public area stating that toilet facilities are not provided. (113725.1, 114276, 114381 (e))
2.00 Post permit in a conspicuous place (It is recommended that the permit be in customer view.). Post a notice advising patrons that a copy of the most recent routine inspection report is available for review by interested parties. Keep a copy of the most recent health inspection report at the facility for customer review purposes.

Post and maintain a legible and conspicuous sign in each toilet room directing attention to the need to thoroughly wash hands after using the toilet.

Post and maintain a legible "No Smoking" sign in food preparation, food storage, and utensil washing areas.

(REPEAT VIOLATION)(CDI) Observed lack of knowledge of the location of a copy of the most recent health inspection at the facility location. Maintain a copy of the most recent health inspection at the facility location, and ensure that employees are aware of its whereabouts and can provide a copy for customer inspection during all hours of operation. A new copy of most recent inspection report is being provided to the facility on this date. Corrected during inspection. 0101 FOOD ESTAB. W/FOOD PREP 0-49 SEATS (HM4)