| 12-08-2023 |
Handwashing soap and single use towels or drying device shall be provided in dispensers adjacent to each handwashing facility; dispensers shall be maintained in good repair. (113953.2) Adequate separate facilities shall be provided for handwashing, food preparation, and the washing of utensils and equipment. (113953, 113953.1)
| 3.00 |
Handwashing facilities shall be sufficient in number and conveniently located so as to be accessible at all times for use by food employees. Employees shall not clean their hands in a sink used for food preparation, warewashing, or in a service sink or a curbed cleaning facility used for the disposal of mop water and similar liquid waste. Do not place objects in front of the handwashing station, and do not place items, utensils or wiping cloths in the handwashing sink.
Handwashing facilities shall be equipped to provide warm water under pressure for a minimum of 15 seconds. If the temperature of water provided is not readily adjustable at the faucet, the temperature of the water shall be at least 100°F, but not greater than 108°F. Soap shall be provided in approved dispensers at, or adjacent to, handwashing facilities (no bars of soap). Single-use sanitary towels or hot-air blowers shall be provided at handwashing facilities in approved dispensing devices.
|
1) HANDWASHING STATION NEAR THE AUTOMATIC DISHWASHER: Observed a broken, non-functional soap dispenser. Repair or replace.
2) HANDWASHING STATION BELOW THE RED MENUS: Observed single-use brown paper towels in an opened dispenser located directly next to the faucet. The dispenser does not provide clean, uncontaminated single-use paper towels each time because a person with wet hands will contaminate the towels underneath the top one and the paper towels are subjected to water splashing from washing hands. Provide a different dispenser (similar to the unit near the dishwasher).
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 12-08-2023 |
Food shall be stored in an approved manner, in approved containers and labeled as to contents. Food shall be stored at least 6" above the floor on approved shelving. (114047, 114049, 114051, 114053, 114055, 114067(h), 114069)
| 1.00 |
Provide adequate and suitable space for the storage of food. Store food at least 6 inches off the floor. Store bulk food not stored in original packaging in containers identifying the food by common name. Food shall not be stored in locker rooms, restrooms, dressing rooms, refuse areas, or mechanical rooms; under open stairwells; under lines on which water has condensed; under leaking water lines, including leaking automatic fire sprinkler heads: or under sewer lines that are not shielded to intercept potential drips.
Only prepackaged nonpotentially hazardous food or uncut produce may be displayed or sold outdoors by a food facility if outdoor displays have overhead protection that extends over all food items, and if all food items from the outdoor display are stored inside the fully enclosed food facility at all times other than during business hours.
Products that are held by the permit holder for credit, redemption, or return to the distributor, such as damaged, spoiled, or recalled products, shall be segregated and held in designated areas that are separated from food, equipment, utensils, linens, and single-use articles. All returned or damaged food products and food products from which the label has been removed shall be separated and stored in a separate area and in a manner that shall prevent adulteration of other foods and shall not contribute to a vermin problem.
|
1) BOXES OF CUPS NEAR THE STORAGE CABINETS (OLIVE AVE SIDE): Observed boxes of cups stored directly on the floor. Store food-related products at least 6 inches off the floor.
2) 1-DOOR DELFIELD REFRIGERATOR NEAR THE DRIVE-THRU REFRIGERATOR: Observed the refrigerator door did not fully close due to too many square-shaped lemonade containers inside the unit. There were 3 containers on the top shelf and 3 containers on the bottom shelf. Discontinue this practice of overloading the refrigeration unit causing the refrigerator door to not fully close and cold air to escape from the unit. On site manager was notified and removed the extra container.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 12-08-2023 |
The walls / ceilings shall have durable, smooth, nonabsorbent, light-colored, and washable surfaces. All floor surfaces, other than the customer service areas, shall be approved, smooth, durable and made of nonabsorbent material that is easily cleanable. Approved base coving shall be provided in all areas, except customer service areas and where food is stored in original unopened containers. Food facilities shall be fully enclosed. All food facilities shall be kept clean and in good repair. (114065, 114067, 114069, 114175, 114143, 114257, 114259.2, 114266, 114268, 114268.1, 114271, 114272)
| 1.00 |
All food facilities shall be kept clean, fully operative, and in good repair. Floor surfaces in all areas in which food is prepared, packaged or stored, where any utensil is washed, where refuse or garbage is stored, where janitorial facilities are located, and in all restrooms and hand washing areas shall be smooth and of durable construction and made from non absorbent material that is easily cleanable.
Each permanent food facility shall be fully enclosed in a building consisting of permanent floors, walls, and an overhead structure that meets minimum standards. Food facilities that are not fully enclosed on all sides and that are in operation on January 1, 1985, shall not be required to meet the requirements of this section until the facility is remodeled or has a significant menu change or a change in its method of operation. Full enclosure is not required for dining areas and certain other areas when approved for outdoor food services.
|
ICE MACHINE AREA: Observed accumulation of debris (plastic food wrap) on the floor underneath the machine. Clean.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 12-08-2023 |
Food facilities that prepare food shall be equipped with warewashing facilities. Testing equipment and materials shall be provided to measure the applicable sanitization method. (114067(f,g), 114099, 114099.1, 114099.2, 114099.3, 114099.4, 114099.5, 114099.6, 114099.7, 114101, 114101.1, 114101.2, 114103, 114107, 114125)
| 2.00 |
Provide a sink with at least 3 compartments with 2 integral metal drainboards. The sink compartments and drainage facilities shall be large enough to accommodate the largest utensil or piece of equipment to be cleaned therein.
Clean the utensils in one of the following ways:
(1) Manual warewashing shall be accomplished by using a 3-compartment sink where the utensils are first pre-cleaned, then washed, rinsed, sanitized, and air dried. The temperature of the washing solution shall be maintained at not less than 100°F or the temperature specified on the cleaning agent manufacturer's label instructions. The utensils shall then be rinsed in clear water before being immersed in a sanitizing solution. Manual sanitization shall be accomplished in the final sanitizing rinse by one of the following: (a) Immersion for at least 30 seconds where the water temperature is maintained at 171°F or above. (b) The application of sanitizing chemicals by immersion, manual swabbing, or brushing, using one of the following solutions: (1) Contact with a solution of 100 ppm available chlorine solution for at least 30 seconds. (2) Contact with a solution of 25 ppm available iodine for at least one minute. (3) Contact with a solution of 200 ppm quaternary ammonium for at least one minute. (4) Contact with a solution of ozone that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations and that is generated by a device located onsite at the food facility that meets all of the requirements of 114099.6. (c) Other methods approved by the enforcement agency.
(2) Mechanical machine warewashing shall be accomplished by using an approved machine installed and operated in accordance with the manufacturer's specifications. Soiled items to be cleaned in a warewashing machine shall be loaded in racks, trays, or baskets or onto conveyors in a position that exposes the items to the unobstructed spray during all cycles and allows the items to drain. Mechanical sanitization shall be accomplished in the final sanitizing rinse by one of the following: (a) By being cycled through equipment achieving a utensil surface temperature of 160°F or above. (b) The mechanical application of sanitizing chemicals by pressure spraying methods using one of the following: (1) Contact with a solution of 50 ppm available chlorine solution for at least 30 seconds. (2) Contact with a solution of 25 ppm available iodine for at least one minute. (3) Contact with any chemical sanitizer that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations when used in accordance with both the sanitizer manufacturers use directions and the machine manufacturer's specifications.
Provide testing equipment and materials to adequately measure the applicable sanitization method.
|
Repeat violation
AUTOMATIC DISHWASHER: The dishwasher does hot water sanitization. Observed lack of thermolabels or a max reading thermometer to measure the mechanical sanitization temperature. Provide.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|
| 12-08-2023 |
All utensils and equipment shall be fully operative, clean, and in good repair. (114115, 114175). All utensils and equipment shall be approved, installed properly, and meet applicable standards. (114130, 114130.1, 114130.2, 114130.3, 114130.4, 114130.5, 114130.6, 114132, 114133, 114137, 114139, 114143, 114153, 114155, 114163, 114165, 114167, 114169, 114172, 114175, 114177, 114180, 114182)
| 1.00 |
Equipment food-contact surfaces and utensils shall be clean to sight and touch. The food-contact surfaces of cooking equipment and pans shall be kept free of encrusted grease deposits and other debris accumulations.
Keep all food facilities, and all utensils, display cases, windows, counters, shelves, tables, refrigeration units, sinks, dishwashing machines, and other equipment or utensils used in the storage, preparation, sale, service, and display of food, clean, fully operative, and in good repair.
The non-food-contact surfaces of equipment shall be kept free of an accumulation of dust, dirt, food residue, and other debris. Equipment shall be reassembled so that food-contact surfaces are not contaminated.
|
1) CABINET STORING CHEMICALS NEAR THE CUSTOMER SELF-SERVE AREA (OLIVE AVE SIDE): Observed broken hinges on the left side cabinet door. Repair.
2) CABINET STORING BOXES OF INDIVIDUALLY-WRAPPED SPOONS (OLIVE AVE SIDE): Observed the bottom of the left side door was loose from the hinge and the door was hanging on the top hinge only. Repair or replace.
3) 1-DOOR JOE TAP FRIDGE: Observed sticky adhesive shipping material inside the unit walls and door. Material is to used to protect the unit during shipping and must be removed prior to use. Remove.
|
0102 FOOD ESTAB. W/FOOD PREP 50-149 SEATS
|