12-22-2020 |
Handwashing signs shall be posted in each toilet room, directing attention to the need to thoroughly wash hands after using the restroom. (113953.5)
No smoking signs shall be posted in food preparation, food storage, and warewashing areas. (113978)
Consumers shall be notified that clean tableware is to be used when they return to self-service areas such as salad bars and buffets. (114075)
Any food facility constructed before January 1, 2004 without public toilet facilities shall prominently post a sign within the food facility in a public area stating that toilet facilities are not provided. (113725.1, 114276, 114381 (e))
| 2.00 |
Post permit in a conspicuous place (It is recommended that the permit be in customer view.). Post a notice advising patrons that a copy of the most recent routine inspection report is available for review by interested parties. Keep a copy of the most recent health inspection report at the facility for customer review purposes.
Post and maintain a legible and conspicuous sign in each toilet room directing attention to the need to thoroughly wash hands after using the toilet.
Post and maintain a legible "No Smoking" sign in food preparation, food storage, and utensil washing areas.
|
(REPEAT VIOLATION) Observed lack of a visibly posted notice to inform patrons that the facility is inspected by the local health department. Maintain a sign in a conspicuous location to inform patrons that the facility is inspected. (A copy of the required notice is available on the Merced County Environmental Health website).
|
0112 RETAIL MARKET 6001-15000 SQFT
|
12-22-2020 |
The potable water supply shall be protected with a backflow or back siphonage protection device, as required by applicable plumbing codes. (114192) All plumbing and plumbing fixtures shall be installed in compliance with local plumbing ordinances, shall be maintained so as to prevent any contamination, and shall be kept clean, fully operative, and in good repair. Any hose used for conveying potable water shall be of approved materials, labeled, properly stored, and used for no other purpose. (114171, 114189.1, 114190, 114192.1, 114193, 114193.1, 114195, 114197, 114199, 114201, 114269)
| 1.00 |
All plumbing and plumbing fixtures shall be installed in compliance with local plumbing ordinances, shall be maintained so as to prevent any contamination, and shall be kept clean, fully operative, and in good repair.
|
Observed the temperature of the water at the hand wash station in the first restroom with the press nozzles was measured above 108F when hot water was on only, and below 100F when cold water was added. Hand wash temperature must be between 100F - 108F. Corrected during inspection.
|
0112 RETAIL MARKET 6001-15000 SQFT
|
12-22-2020 |
Food facilities that prepare food shall be equipped with warewashing facilities. Testing equipment and materials shall be provided to measure the applicable sanitization method. (114067(f,g), 114099, 114099.1, 114099.2, 114099.3, 114099.4, 114099.5, 114099.6, 114099.7, 114101, 114101.1, 114101.2, 114103, 114107, 114125)
| 1.00 |
Provide a sink with at least 3 compartments with 2 integral metal drainboards. The sink compartments and drainage facilities shall be large enough to accommodate the largest utensil or piece of equipment to be cleaned therein.
Clean the utensils in one of the following ways:
(1) Manual warewashing shall be accomplished by using a 3-compartment sink where the utensils are first pre-cleaned, then washed, rinsed, sanitized, and air dried. The temperature of the washing solution shall be maintained at not less than 100°F or the temperature specified on the cleaning agent manufacturer's label instructions. The utensils shall then be rinsed in clear water before being immersed in a sanitizing solution. Manual sanitization shall be accomplished in the final sanitizing rinse by one of the following: (a) Immersion for at least 30 seconds where the water temperature is maintained at 171°F or above. (b) The application of sanitizing chemicals by immersion, manual swabbing, or brushing, using one of the following solutions: (1) Contact with a solution of 100 ppm available chlorine solution for at least 30 seconds. (2) Contact with a solution of 25 ppm available iodine for at least one minute. (3) Contact with a solution of 200 ppm quaternary ammonium for at least one minute. (4) Contact with a solution of ozone that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations and that is generated by a device located onsite at the food facility that meets all of the requirements of 114099.6. (c) Other methods approved by the enforcement agency.
(2) Mechanical machine warewashing shall be accomplished by using an approved machine installed and operated in accordance with the manufacturer's specifications. Soiled items to be cleaned in a warewashing machine shall be loaded in racks, trays, or baskets or onto conveyors in a position that exposes the items to the unobstructed spray during all cycles and allows the items to drain. Mechanical sanitization shall be accomplished in the final sanitizing rinse by one of the following: (a) By being cycled through equipment achieving a utensil surface temperature of 160°F or above. (b) The mechanical application of sanitizing chemicals by pressure spraying methods using one of the following: (1) Contact with a solution of 50 ppm available chlorine solution for at least 30 seconds. (2) Contact with a solution of 25 ppm available iodine for at least one minute. (3) Contact with any chemical sanitizer that meets the requirements of Section 180.940 of Title 40 of the Code of Federal Regulations when used in accordance with both the sanitizer manufacturers use directions and the machine manufacturer's specifications.
Provide testing equipment and materials to adequately measure the applicable sanitization method.
|
Observed lack of chlorine test strips to measure the applicable manual sanitizer concentration. Obtain and use test strips to verify sanitizer is of sufficient strength to act as an appropriate manual sanitizing agent (100 ppm for chlorine, 200 ppm for quat ammonia).
|
0112 RETAIL MARKET 6001-15000 SQFT
|